Attaching the Portable Computer

** Make sure that you hold your computer firmly throughout this process**

1) Pull on front bungee cords and place them beneath the front panel corners

2) Open notebook computer to a 90 degree angle and slide the screen into the rear bungee cord until the cord reaches the bottom of the screen. Continue to hold the computer firmly as you place it on top of the RollerTop™ top panel.

3) While holding firmly on one side, bring the opposite side’s front bungee cord over the front corner of the computer, securing that side. Hold firmly the opposite side and repeat that step for the opposite side corner.

4) Adjust bungee cord by first pulling down on both sides of the bottom section, then pulling on the front, and securing with cord lock.

Removing the Portable Computer

** Make sure that you hold your computer firmly throughout this process**

1) Loosen bungee cord lock

2) Hold notebook computer firmly with one hand on one side and with the other hand grab front bungee cord and place it beneath the RollerTop top panel front corner. Then hold notebook computer on the opposite side and repeat process on the opposite bungee cord side.

3) Hold the computer firmly and slide it out from the rear bungee cord loop until the computer is completely free. Place the computer inside the roller briefcase or in a safe place.