Installing the RollerTop™

Important:

If your roller bag does not stand up by itself or is not stable with the handle upright it may not be a good candidate for the RollerTop™. Make sure RollerTop™ is properly installed and computer is safely attached by reading these instructions.

1) Place the roller bag in front of you, with the back side facing towards you.

2) Raise the roller bag handle to the desired height, and make sure it is locked in position. Some handles require to be lowered completely before raising and locking at the desired height.

3) Open RollerTop by releasing buckle clip

4) Slide roller bag handle through elastic bungee cord

5) Place the top panel of the RollerTop™ next to the Roller bag’s handle with the D-ring right on top of the handle. Position the strap in front of the handle and pass the male buckle through the D-ring, keeping the handle inside the strap loop.

6) Pull until the strap tightens against the handle, keeping the upper panel firm against the handle.

7) Lift bungee cord and close the buckle clip underneath

8) Pull on the strap, thread strap through upper panel slot and continue to pull until desired angle is achieved

9) Apply light pressure on top panel, and make sure the RollerTop™ is firmly attached, and desired angle is achieved